User guide

Regen Resistor Sizing and Configuration Xenus XTL User Guide
142 Copley Controls Corp.
A.2: Configuring a Custom Regen Resistor
A.2.1: Regen Configuration Objective and Warning
Configure the amplifier to operate properly with the custom resistor.
Incorrect values may damage amplifier or external regen resistor.
!
WARNING
For the regen I
2
T algorithms to work correctly, the values entered in the following
steps must be correct. Damage to the external regen resistor may result from
incorrect values entered. Damage to the amplifier may result if an incorrect
resistance value is entered.
Failure to heed this warning can cause equipment damage.
A.2.2: Regen Configuration Instructions
A.2.2.1 Click Configure Regen to open the Regen Resistor screen.
A.2.2.2 If configuring a standard Copley Controls regen resistor, select the model number and
click Finish to save the configuration and close the screen.
Otherwise, continue Select Custom Resistor and then click Configure to open the
Custom Regen Configuration screen.
A.2.2.3 Enter a Resistance within the range described on the screen. Click Next for Step 2.