User guide

Xenus XTL User Guide Xenus Filter

Copley Controls Corp. 161

D.5.3: Cable Notes

1 Keep the Edge Filter J1 to Xenus J2 cable as short as possible. A typical length is 7 inches.

2 To reduce noise, twisted shielded cable must be used and the signal cables should not be

bundled in the same conduit.

D.5.4: Input (J1) From Amplifier

Mating Connector

Description Euro-style, 5 position, 5.0 mm pluggable female terminal block

Manufacturer PN Wago 51118042 or 721-105/026-047/RN01-0000

Wire Size 22 - 12 AWG

Recommended Wire 12 AWG, 600 V

(Shielded cable used for CE compliance)

Wire Insertion/Extraction Tool Wago 231-131

Connector and tool are included in connector kit XTL-FK.

Pin Description

Pin Signal Function

1 Ground Chassis ground and cable shield

2 Phase W Phase W input from amplifier

3 Phase V Phase V input from amplifier (use for DC motor connection)

4 Phase U Phase U input from amplifier (use for DC motor connection)

5 --- No connection

D.5.5: Output (J2) To Motor

Mating Connector

Description Euro-style, 4 position, 5.0 mm pluggable female terminal block.

Manufacturer PN Wago 51118008 or 721-104/026-047/RN01-0000