User guide

ManualsBrandsCopley Controls ManualsMedia ConverterSerial Encoder

Wiring Xenus XTL User Guide

54 Copley Controls Corp.

4.7: CAN Bus (J6)

Mating Connector

8-position, modular connector (RJ-45 style). Copley Controls provides the following assemblies:

• Prefabricated 10 foot cable, PN XTL-NC-10

• Prefabricated 1 foot cable, PN XTL-NC-01

• Terminator Plug, PN XTL-NT

A diagram of the female connector is shown below.

12345678

Pin Description*

Pin Signal Function

1 CAN_H CAN_H bus line (dominant high)

2 CAN _L CAN_L bus line (dominant low)

3 CAN_Gnd Ground / 0 V / V-

4 -- No connection

5 -- Pass though to second connector, no internal connection

6 CAN_SHLD Pass though to second connector, no internal connection

7 CAN_Gnd Ground / 0 V / V-

8 CAN V+ Pass through to second connector, no internal connection

*Table applies to both CAN connectors

CAN Bus Wiring Diagram

Amplifier J6

CAN +

CAN

CAN Gnd

CAN +

CAN

CAN Gnd

Note 1: If this is the last amplifier on the network,

use Copley Terminator Plug PN STP-NT

to terminate the bus.

CAN Network

J6-1

J6-2

J6-4

J6-3

J6-5

J6-6

J6-7

J6-8