User guide

Parameter Dictionary Introduction
Cross references for each parameter include, where applicable, the equivalent DeviceNet variable ID, MACRO I-variable ID, and CANopen (and
EtherCAT) object index and sub-index.
1.3: Important Notes
1.3.1: CME 2 Refresh Behavior
When parameters are changed using one of the interfaces described in this manual, the changes will not necessarily be recognized by an active
CME 2 session.
1.3.2: Input/Output Numbering
Inputs and Outputs on Copley drives are numbered starting from zero for all of the communication interfaces listed in this document. If a drive
has 12 inputs, they are numbered 0 through 11. CME 2 software starts numbering at 1 (input 0 is called IN1 in CME 2 software).
Copley Controls Page 10