User guide

Xenus Plus User Guide Wiring
Copley Controls 80
4.1: General Wiring Instructions
4.1.1: Electrical Codes and Warnings
Be sure that all wiring complies with the National Electrical Code (NEC) or its national equivalent,
and all prevailing local codes.
DANGER
DANGER: Hazardous voltages.
Exercise caution when installing and adjusting.
Failure to heed this warning can cause equipment damage, injury, or death.
DANGER
Risk of electric shock.
High-voltage circuits connected to mains power.
XEL/XPL/XML
J1, J2, J3
XE2/XP2/
800-1782/800-1808
J1, J2, J3, and J4
Failure to heed this warning can cause equipment damage, injury, or death.
DANGER
Refer to the Xenus Plus Dual-Axis STO User Manual
The information provided in the Xenus Plus Dual-Axis STO User Manual must be
considered for any application using the XE2/XP2/800-1782/800-1808 drive STO
feature.
Failure to heed this warning can cause equipment damage, injury, or death.
WARNING
Do not plug or unplug connectors with power applied.
The connecting or disconnecting of cables while the drive has 24Vdc and/or mains
power applied is not recommended.
Failure to heed this warning may cause equipment damage.
WARNING
Do not ground mains-connected circuits.
Do not ground Mains connected circuits: J1, J2, J3 and J4 for XE2/XP2/800-
1782/800-1808; J1, J2 and J3 for XEL/XPL/XML.
Failure to heed this warning can cause equipment damage.
WARNING
Risk of Radio Frequency Interference
The Xenus Plus Dual Axis drives are not intended for use on a low-voltage public
network which supplies domestic premises.
Radio frequency interference should be expected if used on such a network
!
!
!
!
!
!