User guide

Amplifier Setup Procedure CME 2 User Guide
28 Copley Controls
3.1: Warnings and Notes
NOTE: To immediately software disable the amplifier at any time while running CME 2,
press function key F12. Also, the amplifier’s enable input can be used to disable the
amplifier.
!
DANGER
DANGER: Hazardous voltages.
Exercise caution when installing and adjusting.
Do not make connections to motor or drive with power applied.
Risk of unexpected or uncontrolled motion with CME 2 in CAN mode.
CME 2 can be used while the amplifier is under CAN or EtherCAT control.
However, some extreme changes made with CME 2 could cause unexpected
or uncontrolled motion.
Failure to heed these warnings can cause equipment damage, injury, or
death.
!
WARNING
Spinning motor with power off may damage amplifier.
Do not spin motors with power off. Voltages generated by a motor can
damage an amplifier.
Failure to heed this warning can cause equipment damage.