SDS

Page 3/8
Safety Data Sheet
29 CFR 1910.1200
Printing date 06/28/2018 Reviewed on 06/27/2018Version number 1
Trade name:
HOT COLD PACK
(Contd. of page 2)
47.0.4
Wear fully protective suit.
6 Accidental release measures
·
Personal precautions, protective equipment and emergency procedures:
Ensure adequate ventilation.
Use respiratory protective device against the effects of fumes/dust/aerosol.
Avoid contact with eyes.
Avoid contact with skin.
·
Environmental precautions:
Do not allow to enter sewers/ surface or ground water.
·
Methods and material for containment and cleaning up:
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to item 13.
7 Handling and storage
·
Precautions for safe handling:
Keep away from heat and direct sunlight.
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
Avoid contact with eyes and skin.
For the general occupational hygienic measures refer to Section 8.
·
Information about protection against explosions and fires:
Normal measures for preventive fire protection.
·
Conditions for safe storage, including any incompatibilities
·
Requirements to be met by storerooms and receptacles:
Store in a cool location.
·
Information about storage in one common storage facility:
Store away from foodstuffs.
·
Further information about storage conditions:
Store in cool, dry conditions in well sealed receptacles.
8 Exposure controls/personal protection
·
Control parameters
·
Components with limit values that require monitoring at the workplace:
56-81-5 glycerol (30.0%)
PEL (USA) Long-term value: 15* 5** mg/m³
mist; *total dust **respirable fraction
TLV (USA) TLV withdrawn-insufficient data human occup. exp.
·
Regulatory information
PEL (USA): Guide to Occupational Exposure Values (OSHA PELs)
TLV (USA): Guide to Occupational Exposure Values (ACGIH)
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Based on the composition shown in Section 3, the following measures are suggested for occupational safety
measure
·
Appropriate engineering controls:
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid close or long term contact with the skin.
See Section 7 for information about design of technical facilities.
·
Personal protective equipment
·
Breathing equipment:
Suitable respiratory protective device recommended.
(Contd. on page 4)
USA