User's Manual

M ORPHO ™ R AP ID QUICK U SER ’ S G UIDE Battery
0000025754-07 - AUGUST 2009 7
S AGEM S ÉCURITÉ D OCUMENT - R EPRODUCTION AND D ISCLOSURE P ROHIBITED .
Battery Transportation
It is recommended to remove batteries from the terminal when the product is transported on long distance.
Battery Charge
It is mandatory to only use the battery charger delivered by Sagem Sécurité for the MorphoRapID™
product for MorphoRapID™ battery charge.
The battery pack should be charged within the range of specified temperatures. If the pack is charged at a
temperature out of the specified range, leakage, heat generation, or other damages may occur.
The battery pack should be discharged within the range of specified temperatures.
NOTE
Do not use MorphoRapID™
batteries for any other use than the
MorphoRapID™ product.
It should be noted that the battery pack may be overdischarged if the pack is not used for a long time. In
order to prevent overdischarging, the pack should be charged periodically. Overdischarging may cause loss
of pack performance, or damage battery functions.
So as to keep a correct autonomy, it is recommended to regularly perform complete charge/discharge cycles.
WARNING
To switch the terminal off for a period of storage longer than 7 days, it is
advised to disconnect the battery.
In the same way, to preserve battery life during a long period of storage, it is
advised to disconnect or to remove the battery w
ith a minimum charge of 30%
of battery capacity and not in deep discharge (0%).
Power Supply Precautions
The installation and maintenance of the MorphoRapID™ should be made by a qualified service person and
should conform to all local codes.
Before plugging the power source to your MorphoRapID™, check that the power source you intend to
connect do complies with the voltage, current and frequency specifications on the rating label on the power
supply unit.
NOTE
Use only the power supply unit provided with your MorphoRapID™.