User Manual

14
8.9.2 Start-up Menu: Sets the command to be displayed first when the machine is
powered up and initialized. All primary commands are available to be set for Start-up:
Copy, Test, Copy & Verify, Copy & Compare, etc.

Press
ENT

  or  to select
function and press ENT to
confirm
8.9.3 Skip Read Error: Allows the duplicator to skip uncorrectable read errors on the
master DVD or CD or Blu-ray. This feature can be turned ON or OFF.
8.9.4 Change Bad Master: Allows the changing of the master disc during duplication
when there is an uncorrectable error on the master disc(s) that threatens to disrupt the
copy process.
 Press
ENT 
  or  to select mode and
press ENT to confirm
8.9.5 CD Overburn: Allows the copying of CDs that have been burned over their
maximum capacity.
The target disc(s) must be the same capacity as the master disc.
 Press
ENT 
  or  to select mode and
press ENT to confirm
8.9.6 Show HDD Image: Allows the option to display the name of the HDD image name
(default) or the image size (in MB).
 Press
ENT 
  or  to select Image
Name/ Capacity and press
to ENT confirm
8.9.7 Keep Buffer: You can set Yes to load source disc to buffer in first round of Copy,
Test, Compare or Copy+Compare and do it again without the source disc. Or set No to
keep buffer not be used.
**Note:
The source will be only temporary saved in buffer, there will be nothing left when you exit
the task (Copy, Test, Compare and Copy+Compare) or reboot the system.
8.9.8 Boot Password: Sets password protection for the duplicator before the boot-up
process can be started. The boot password prevents anyone unauthorized from using the
duplicator system.
 Press
ENT 
  or  to select mode
and press ENT to confirm
If Disable is selected, no password will be set and the display will direct back to the
Setup sub-menu.