User Manual

15
If Enable is selected, a password must be entered using the following guidelines:
Use  or  to select the character desired.
Press ENT to go to the next position.
There are a total of 6 positions for the password. To enable the password, set all 6
positions.
For space, press ENT without choosing a character to leave the position empty.
Press ESC to cancel the process.
The duplicator will ask for password when the unit is restarted.
8.9.9 Setup Password: Sets password protection for the duplicator before the setup
settings can be altered. The setup password prevents unauthorized changes to the
system.
 Press
ENT 
  or  to select mode and
press ENT to confirm
If Disable is selected, no password will be set and the display will direct back to the
Setup sub-menu.
If Enable is selected, a password must be entered using the following guidelines:
Use  or  to select the character desired.
Press ENT to go to the next position.
There are a total of 6 positions for the password. To enable the password, set all 6
positions.
For space, press ENT without choosing a character to leave the position empty.
Press ESC to cancel the process.
The duplicator will ask for password when “11. Setup” is selected
9 HDD MANAGER: This command is for the management of the hard disk drive (HDD)
installed in the duplicator. Note: This feature is only available on duplicators with a HDD installed. If
there is no HDD present in the duplicator, this feature will NOT show in the menu of commands
9.1 Select Image: Allows the selection of the image(s) present on the HDD. The Scroll
buttons cycle through the image(s) on the HDD and the ENT button confirms the
selection while the ESC button cancels the selection. The image(s) are listed in order of
which they were loaded.

Press
ENT

  or  to select
image and
press ENT to confirm