User manual

9
Colocaci—n
Situar el aparato lejos de fuentes de calor, como:
radiadores, estufas, exposici—n directa a los rayos
del sol, etc.
Asegurarse de que en les partes posterior, superior
e inferior no haya ningœn obst‡culo que impida la
circulacidn del aire.
Para que el aparato rinda mejor, la distancia m’nima
entre la parte superior y el eventual mueble pŽnsil
de encima, deber’a ser por lo menos de 100 mm (A).
La soluci—n preferible, de todos modos, seria la
ilustrada en la B (sin mueble).
Dos patas graduables, situadas en la base del
mueble, consienten rivelarlo a la perfecci—n.
Asegurarse de que la toma de corriente y el enchute
sean compatibles entre s’ sin tener que interponer
reducciones ladrones o adaptadores varios. Si fuera
necesario, cambiar la toma de la instalaci—n de la
casa con una adepta.
Importante
Es indispensable conectar el aparato a una toma
de sierra eficaz.
Para eso el enchufe del cable de alimentaci—n est‡
dotado de un adecuado contacto. Si la toma de
corriente de la instalaci—n domŽstica no estuviera
conectada a sierra, conectar el aparato a una
instalaci—n de sierra, conforme a les leyes en vigor,
consultando para ello con un tŽcnico especializado.
El fabricante declina toda responsabilidad en el
caso que esta norma no sea respetada.
Este aparato es conforme a les correspondientes
Normas UNE y a la Norma Comunitaria CEE N. 87/
308 del 2/6/87 relativa a la supresi—n de
interferencias radio.
Este aparato es conforme a les siguientes
Directivas Comunitarias:
- 73/23 CEE 19/02/73 (Baja tensi—n) y
modificaciones sucesivas;
- 89/336 CEE 03/05/89 (Compatibilidad
electromagnŽtica) y modificaciones sucesivas.
Conexi—n elŽctrica
Antes de enehufar el aparato, asegurarse de que la
tensi—n y la frecuencia indicadas en la tarjeta
matricula, correspondan a les de la instalaci—n
domŽstica. Se admite una oscilaci—n de 6% sobre la
tensi—n nominal. Para el funcionamiento a tensiones
distintas, habr‡ que utilizar un autotransformador de
potencia adecuada.
INSTALACIîN
100 mm10 mm
10 mm
A
B
NP006
12
Warnings 11
Use 13
Cleaning the interior 13
Control panel 13
Operation 13
Temperature regulation 13
Fast freezing 13
Warning light 13
Freezing fresh food 14
Storage of frozen food 14
Thawing 14
Ice-cube production 14
Hints 15
Hints for freezing 15
Hints for storage of frozen food 15
Maintenance 16
Internal cleaning 16
External cleaning 16
Periods of no operation 16
Defrosting 16
Customer service and spare parts 17
Technical information 17
Installation 18
Location 18
Electrical connection 18
Rear spacers 19
Door reversal 19
CONTENTS
mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
¥ During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
¥ Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
¥ If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
¥ There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
¥ Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol are recyclable.