User manual

Rear spacers

In the bag with the documentation, there are two

spacers which must be fitted in the two top corners.

Slacken the screws and insert the scraper under the

screw head, then re-tighten the screws.

D594

D590

D715

PR228

Door reversal

Unplug the appliance before all operations.

To reverse the door, proceed as follows:

1. dismantle the lower hinge (1), feet (2);

2. slide the door out from pin (G),unscrew the pin

and reposition on the opposite side;

3. unscrew the left front foot (3) and reposition on

the opposite side;

4. unscrew the two screws which mask the holes for

fixing the hinge from the left front side;

5. reassemble the door;

6. reassemble the lower hinge and the screw on

the opposite side, as shown in the figure;

7. remove the handle, after having removed the

screw cover and refit it on the opposite side. The

holes that are not used must be mask with the

plastic plugs removed.

Warning:

After having reversed the opening direction of

the doors check that all the screws are properly

tightened and that the magnetic seal adheres to

the cabinet. If the ambient temperature is cold (i.e.

in Wõnter), the gasket may not fit perfectly to the

cabinet. In that case, wait for the natural fitting of the

gasket or accelerate this process by heating up the

part involved with a normal hairdrier.