User manual

5
PR187
D040
Calendario de productos
congelados
Los símbolos indican diferentes tipos de productos
congelados.
Las cifras indican el tiempo de conservación en
meses para cada tipo de producto congelado. La
validez del valor máximo o mínimo establecido del
tiempo de conservación de los productos
congelados depende de la calidad y de la
preparación de ellos antes de ser congelados.
10 -1210 -1210 -1210 -123-63-63-63-63-41-2
Rejillas movibles
En las paredes del compartimento existen unas
guías que permiten poner las rejillas a distintas
alturas.
Ubicación mensulas de la
contrapuerta
Se puede cambiar la posición de las mensulas de la
contrapuerta.
La operación se efectúa de la siguiente manera:
Empujar gradualmente el estante en el sentido
indicado por las flechas hasta llegar a
desengancharlo, luego volverlo a montar en la
posición deseada.
CONSEJOS
Consejos para refrigeración
Para un correcto uso aconsejamos:
Carne: debe ser envuelta en bolsas de plástico y
colocada en el espacio situado sobre los cajones
verdura.
En esta posicíon la carne puede ser conservada
como máximo durante 1 a 2 dias.
Alimentos cocinados , platos fríos, etc. tienen
que conservarse bien cubiertos y se pueden colocar
en cualquier bandeja del frigorífico.
Fruta y verdura: una vez lavada, ha de colocarse
en el cajón (cajones) inferior.
Mantequilla y queso: deben colocarse en los reci-
pientes adecuados o envueltos en papel de aluminio
o politileno, a fin de evitar el contacto con el aire.
Leche embotellada: bien tapada, en la contrapuerta.
Bananas, patatas, cebollas y ajo, si no están
envueltos, no se deben colocar en frigorífico.
20
Position the runners (A) at the top and bottom of the
inside of the kitchen unit as shown in Fig. and mark
the position of the external holes.
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
Open both the appliance door and that of the kitchen
unit to approx. 90°. Place the little plates over the
runners. Hold the doors of the appliance and the unit
together and mark the holes.
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little platee over the
runners and screw in the screws provided (3.5x16
mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that the
doors of the appliance and the kitchen unit open
properly.
If the appliance is to be fitted laterally to the kitchen
unit, it will be sufficient to loosen the screws of the
little plates (G), move them as shown in Fig. and
then fasten them up again. Fit the cover (H).
The doors can be opened using the sliding system
previously illustrated, or one of the two doors can be
opened by fitting the small handle supplied as an
accessory.
PR33
20mm
A
8mm
PR34
PR35
D729
G
H
G
D029