User manual

Changing the opening direction of

the door

Before buiding-in the appliance (if necessary),

change the opening direction of the door. To do this,

proceed as follows:

1. Remove the lower hinge (1) and feet (3)

2. Slide the door out from pin (G) and place it on the

opposite side;

3. Unscrew the foot front left and place it on the

opposite side;

4. Unscrew the two screws which mask the holes

for fixing the hinge on the front left side;

5. Reassemble the door

6. refit the lower hinge and feet (3) on the opposite

side;

7. dismantle the handle and reassemble it on the

opposite side.Cover the holes left open with the

plugs contained in the documentation pack.

Attention

After completion of the door reversibility

operation, verify that the door gasket is adherent

to the cabinet. If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit perfectly to

the cabinet. In that case, wait for the natural

fitting of the gasket or accelerate this process by

heating up the part involved with a normal

hairdrier.

PR228

D715 PIED/C

Rear spacers

Inside the appliance you find two spacers which

must be fitted as shown in the figure.

Slacken the screws and insert the spacer under the

screw head, then re-tighten the screws.