User manual

27
For refitting the upper door holder take out the
screws (2 pieces) fixing the plastic top on the back
of the box.
Push back the top and lift it from the fixing
elements.
Unscrew the screws fixing the upper door holder
(2 pieces).
After unscrewing turn over the pin in the door
holder plate in the direction of the arrow.
Fit and fix the door holder plate on the other side
without displacing the door.
Put back the plastic top on the fixing elements and
pull it forward.
Fix the top with the screws (2 pieces) on the back
side of the box.
Put over the handle and the plastic nails on the
other side.
Put the appliance to its place, set it level and plug it
into the mains socket.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
Electrical connection
This refrigerator is designed to operate on a
230 V AC (
~
) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to
get an electrician to fit an earthed socket in
compliance with standards near the refrigerator.
This appliance complies with the following
E.E.C. Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive)
and subsequent modifications,
89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.