Instruction manual
7-10
● Setting Procedure of Horizontal Timing
7.3.4 Horizontal Timing (Fine Adjustment)
The H-PHASE (FINE) is used to set the horizontal timing.
● Settable Range
±100, in 1 steps
The one step (i.e., ±0.0741 μs) is divided into about ±100.
● Setting Procedure of Horizontal Timing
Display the H-PHASE (COARSE) by using the [
5
] and [
6
]
keys.
Press the ENTER key.
Press the ENTER key.
１．ＧＬ ＳＥＴＴＩＮＧ
t
ＧＥＮＬＯＣＫ ＴＩＭＩＮＧ
２．ＧＥＮＬＯＣＫ ＴＩＭＩＮＧ
v
Ｈ－ＰＨＡＳＥ （ＣＯＡＲＳＥ）
３．Ｈ（ＣＯＡＲＳＥ）Ｒ：２．９９７Ｈｚ
ＧＬ． ＋０．０７４１ μｓ
Display the GENLOCK TIMING by using the [
5
] and [
6
]
keys.
２．ＧＥＮＬＯＣＫ ＴＩＭＩＮＧ
v
Ｈ－ＰＨＡＳＥ （ＣＯＡＲＳＥ）
Press the ENTER key. Press the MENU key to cancel.
Sets the timing by using the [
5
] and [
6
] keys.
The internal reference signal is displayed at the upper-right
corner of the screen.
Display the H-PHASE (FINE) by using the [
5
] and [
6
] keys.
Press the ENTER key
Press the ENTER key.
１．ＧＬ ＳＥＴＴＩＮＧ
t
ＧＥＮＬＯＣＫ ＴＩＭＩＮＧ
２．ＧＥＮＬＯＣＫ ＴＩＭＩＮＧ
t
Ｈ－ＰＨＡＳＥ （ＦＩＮＥ）
３．Ｈ（ＦＩＮＥ） Ｒ：２．９９７Ｈｚ
ＧＬ． ０
Display the GENLOCK TIMING by using the [
5
] and [
6
] keys.
２．ＧＥＮＬＯＣＫ ＴＩＭＩＮＧ
t
Ｈ－ＰＨＡＳＥ （ＦＩＮＥ）
Press the ENTER key. Press the MENU key to cancel.
Sets the timing by using the [
5
] and [
6
] keys.
The internal reference signal is displayed at the upper-right corne
r
of the screen.