User manual
29
SERVICING
PRA01GB
Certain problems are due to lack of simple mainten-
ance or oversights and can be solved easily without
having to call out an engineer.
The machine will not start
■ The door has not been properly closed.
■ The plug is not properly inserted in the power socket.
■ There is no current at the socket. Check the fuse.
The machine will not fill with water
■ The water tap is shut.
■ The water supply has been cut off.
■ The inlet hose is kinked.
■ The water inlet hose filter is clogged.
The machine will not drain
■ The drain hose is kinked.
■ The sink drain is blocked.
■ The drain hose extension is not correct.
■ There is no air vent in the end of the drain hose.
The dishes are not clean (poor wash)
■ The baskets are too full.
■ The dishes have not been arranged properly.
■ The spray arms do not rotate.
■ The spray arm holes are clogged.
■ The end of the drain hose is submerged in waste
water (in the sink).
■ The filters are clogged.
■ The filters are not in position.
■ Not enough detergent has been used or it is un-
suitable.
■ The detergent is old or has gone hard.
■ The salt container cap is not properly closed.
■ The washing programme selected is too gentle.
Visible lime deposits or white film on the dishes
■ There is no salt or the softener has not been adjusted
to the hardness of the water.
■ The rinse aid has run out or too little is being used.
The machine is noisy
■ The dishes are rattling against each other.
■ The spray arms are knocking against the dishes.
The dishes are not quite dry
■ The dishes have been left too long inside the
machine.
The door is difficult to close
■ The dishwasher is not level or is not properly built-in.
If, after the above checks, the fault persists, call your
nearest Service Centre, indicating the fault, the appli-
ance model (Mod.), the product number (Prod. No.)
and the serial number (Ser. No.). This information can
be found on the rating plate located on the right-
hand side of the dishwasher door (see picture).
Prod.No.
........
Ser. No.
.........
Mod.
........
RA01