Installation Guide

CAUTION
· TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH
ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.
· INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR
CERTIFIED FACTORY TRAINED TECHNICIAN.
· If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached.
DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.
In regular circumstances the BLACK wire will be the "Hot" lead and the WHITE wire will be the "Neutral" or "Common" lead. The
GREEN or BARE COPPER wire is the "Ground". In older buildings it is always good practice to reconfirm the polarity of the wiring.
Page 1 of 3
L I
G
H T I N
R
G
NOTICE
· The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that
may occur. it must be understood that common sense, caution and care factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and caring of this lighting fixture.
· This fixture is designed to be mounted on a correctly installed standard round or octagon box or a through wiring box
with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied
should be used. directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
· This fixture is supplied with with a 4-pcs. stem. There is one 6" section, two 12" section and one 18" section.
This feature allows the fixture to be mounted with a stem up to 48" in length in 6" increments (See Figure-3).
· This fixture is supplied with a swivel. By rotating the canopy the fixture may be mounted to angled ceiling.
FIXTURE PREPARATION
1. Remove the fixture, metal prism and parts bag(s) from the carton.
NOTICE:
Before discarding the carton,
double check to make certain that all parts are found.
2. Thread the stem connector onto the coupling.
3. Determine the overall desired length of the fixture.
Assemble the adjustable stems one at a time onto the fixture leads.
Tape the end of the leads to a stiff wire (coat hanger) to aid in pulling
them through the stems. Place the canopy with the ss accent onto
the stem. Assemble the fixture stem and swivel.
FIGURE-1
Canopy
Adjustable stem
Ceiling
Swivel
SAFETY CABLE
Structure or Brace
Outlet box
Cable clip
Swivel Block
Small Hex Nut
Ball Nut
SS Accent
Mounting Strap
Green Screw
185-44 TANTRUM XLARGE PENDANT INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
LED
DRIVER
D-154
LED Driver