Installation Sheet

ManualsBrandsCorbin Russwin ManualsHardwareCommercial Panic Proof Grade 1 Extra Heavy Duty Keyed Entry Single Cylinder Storeroom Lever Set with NZD Trim

ASSA ABLOY

In U.S.:

Corbin Russwin, Inc.

225 Episcopal Road

Berlin, CT 06037 USA

www.corbinrusswin.com

In Canada:

ASSA ABLOY Door Security Solutions Canada

160 Four Valley Drive

Vaughan, Ontario, Canada L4K4T9

www.assaabloy.ca

Technical Product Support: Phone: 888-607-5703

Installation Instructions

Grade 1 Key-In-Lever

Cylindrical Lockset

CL3300 Series

FM533 (07/12)

Permission of Corbin Russwin, Inc. is prohibited.

1 of 4

IMPORTANT: The accuracy of the door preparation is critical for the proper functioning and security of this lever

handle lock. Misalignment can cause premature wear and a lessening of security.

Attention Installer

Please read these instructions carefully to prevent

missing important steps.

Please note: Improper installation may result in

damage to the lock and void the factory warranty.

TEST OPERATION: Rotate levers to see that latchbolt moves freely.

DO NOT FORCE.

If lockset does not operate properly, remove lockset from door and check door preparation.

*Standard Installation for 1-3/4" doors.

See page 2 to adjust for other door thicknesses.

Install Latchbolt

Install Lockbody

Install Inside Trim

DOOR

EDGE

DOOR

EDGE

LOCK OR

LATCH

SINGLE

POINT

LOCK OR

LATCH

SINGLE POINT

Line-up Notches

mlw - 07/25/08

Summary of content (4 pages)

PAGE 1
® Installation Instructions Grade 1 Key-In-Lever Cylindrical Lockset CL3300 Series In U.S.: Corbin Russwin, Inc. 225 Episcopal Road Berlin, CT 06037 USA www.corbinrusswin.com ASSA ABLOY In Canada: ASSA ABLOY Door Security Solutions Canada 160 Four Valley Drive Vaughan, Ontario, Canada L4K4T9 www.assaabloy.ca Technical Product Support: Phone: 888-607-5703 IMPORTANT: The accuracy of the door preparation is critical for the proper functioning and security of this lever handle lock.
PAGE 2
Door & Frame Preparation Mark door Locate and mark horizontal center line at desired height above floor. Fold template over edge of door, centering on horizontal line. Mark centers of holes at proper backset. Mark both sides of the door. ® Adjust Lock for Door Thickness ASSA ABLOY Adjust lock to door thickness if other than 1-3/4” (44mm) doors *. (Lock pre-set from factory for 1-3/4” door). A. Remove outside lever (see page 4) B. Slide off outside cassette assembly. C.
PAGE 3
® Cylinder Installation To Install Interchangeable Core (With lever already installed on lock) To Remove Interchangeable Core A. Install Tailpiece ASSA ABLOY A. Insert key marked CONTROL and turn clockwise approximately 15 degrees. See Figure 4. Tailpiece Tailpiece Security Disc** B. Pull core and tailpiece completely out of lever.
PAGE 4
® Lever Removal and Installation ASSA ABLOY LEVER STYLE REMOVAL INSTALL Hold in button, push release tool into release hole, remove lever Push button in, slide lever on. Push / Turn Button RELEASE TOOL Make sure lever will not pull off Plain Lever Push release tool into release hole, remove lever Slide lever over lever catch.