Installation Guide
PATENT PENDING ©2016 Turnberry Innovations. GapSaver is a trademark of Turnberry Innovations, LLC. For more info, visit us at www.GapSaver.com
See it in Action at GapSaver.com
• FIRST, clean debris from tailgate gap
• Lay GapSaver on tailgate with anchor down
• Measure the length of your tailgate
• Mark that length on your GapSaver
• Cut ONE end of GapSaver with utility knife
• Lay GapSaver into tailgate gap
• Mark all obstructions on GapSaver anchor
• Trim anchor to fit around cables, hinges
& other tailgate obstructions
• Open and close tailgate to test GapSaver
• Trim anchor again as needed
COLD WEATHER NOTE:
In cold temperatures, your GapSaver
may take a few minutes to lie flat
TAILGATE
PROTECTOR
INSTALLATION INSTRUCTIONS