Installation Instructions

1. At eyelet tab,
flex open one side
wall and insert a
cord end through the
hole in the divider.
2. Flex open the
opposite side wall
and pull the cord
end all the way
through and out
of the opening.
3. Pull the cord
halfway through
the unit. (Example:
For 50 ft. cord, pull
25 ft. through.)
Cordpro will then
be in the middle
of the cord.
4. Grip Cordpro in
center opening and
wrap cord ends
together initially
and then separately
(if desired) in the
exact SAME
direction. Each
half of the cord
will slide into its
own compartment.
5. To use . . . plug cord into outlet, lay
Cordpro on the ground and pull end of
cord to needed appliance or tool. Cordpro
will unreel just the right length of cord as it
slides with you!
FOR USE WITH HOSES, wind
each half in OPPOSITE directions.
(Both halves will then only unreel from
one side at a time.) This prevents
kinking of the hose.
CORD CORD CORD CORD
LENGTH GAUGE FULLY ON
125 volts & TYPE EXTENDED REEL
100’ /
30 m 10 / 3 9 AMP. 4.5 AMP.
100’ / 30 m 12 / 3 17 AMP. 8.5 AMP.
CAUTION: DO NOT USE CORD ABOVE RATED CAPACITY
DO NOT EXCEED 1/2 CORD RATING IF USED COILED.
AVOID OVERHEATING
All cords generate heat when used.
Know cord and appliance ratings before use.
New cords are labeled for
maximum rated power.
Electrical appliances are
labeled for rated power
consumption.
Patent No. 5,992,787 and
Additional Patents Pending
Made in USA
FOR USE WITH CORDS, wind
cord halves in the SAME direction.
(Both halves will unwind at the same
time.)
Cord Installation and
Use Instructions
Cord
pro
®
(CP-100 unit shown in images)
XL