Installation Guide

ManualsBrandsCORE ManualsPop-Up TentsInstant Canopy 10 ft. x 10 ft. Gray Outdoor Pop Up Shade Canopy Shelter Tent

STITCH LINE

10 x 10 INSTANT CANOPY

Extend Shelter Frame

CAUTION: Avoid pinch points when opening or closing the shelter frame.

• Expand and spread out SHELTER FRAME half way.

(continued on other side)

Model No. 40017

Rev A

Attach Canopy (continued)

• Locate HOOK & LOOP FASTENER

on underside of the corner of the

CANOPY; then attach to material

located at the top of the STEEL

SHELTER LEG.

• Repeat for remaining 3 corners of

the CANOPY.

Secure Canopy to Frame

• Locate HOOK & LOOP FASTENERS along

the seam of the underside of the CANOPY;

then wrap around METAL BRACKET to secure.

• Repeat for remaining 3 sides of the

shelter CANOPY.

• Fasten CLIP on web strap of canopy onto LEG

POLE below LOCKING BUTTON.

• Repeat for remaining 3 legs of the

shelter CANOPY.

NOTE: Pull down on end of the WEB

STRAP to tighten and secure the CANOPY.

• Position the shelter in its ﬁ nal position

before securing with stakes and guylines.

Two people can easily setup this shelter in minutes.

Raising Roof Support Brackets

• To ﬁ nish expanding the frame, grasp the LEG POLE and push up on

the ROOF SUPPORT BRACKET until the GRAY BUTTON “clicks” into

locked position.

• Repeat for remaining 3 ROOF SUPPORT BRACKETS to fully raise the

ROOF PEAK.

Telescoping Steel Frame Legs

• Place foot on the LEG FOOT; then grasp and extend TELESCOPING

LEG POLE until the LOCKING BUTTON “clicks” into locked position.

• Repeat for remaining 3 LEG POLES.

NOTE: When telescoping the legs, the LOCKING BUTTON will lock in the

lowest setting ﬁ rst. Push in the LOCKING BUTTON and extend the leg

further to desired shelter height.

To Secure Shelter

• Locate FOOT at the bottom of each SHELTER LEG POLE (4 total).

• Slide STAKE through HOLE at each location.

• Locate GUYLINES attached to the shelter and unroll.

• Slide STAKE through loop at each location, extend out and drive in

to secure.

NOTE: Extend four corner GUYLINES out at a 45º angle from shelter.

• Tighten GUYLINES as needed by adjusting the SLIDER up the cord.

Contents & Repair Parts:

Joint Endcap (2”)

#90685

Bracket Joint (1”) #91153

Attach Canopy

• Unfold CANOPY then drape over SHELTER FRAME with corners

positioned over SHELTER LEGS.

Shelter Leg

#91154

Outside

Bracket

Pole

#90676B

Center Hub #90682

Apex Support Pole

#90679

Upper Roof Pole #90681

Roof Joint #90683

Lower Roof Pole

#90680

STEEL SHELTER FRAME

STEEL SHELTER LEGS

CANOPY

Not Pictured:

Canopy Top #90673

Stakes #90674

Bracket Pole 40”

#90676A

Apex Joint #90684

UNDERSIDE

OF CANOPY

HOOK & LOOP

FASTENERS

STEEL

SHELTER LEG

GRAY

BUTTON

SUPPORT

BRACKET

LOCKING

BUTTON

LEG FOOT

ROOF PEAK

HOOK & LOOP

FASTENER

METAL

BRACKET

FOOT

SLIDER

3-Stage Height

Adjustability

LOWER

HIGHEST

MEDIUM

LOCKING

BUTTON

CLIP

WEB

STRAP

Summary of content (2 pages)

PAGE 1
STITCH LINE Model No. 40017 Rev A 10 x 10 INSTANT CANOPY 2 Attach Canopy (continued) Two people can easily setup this shelter in minutes.
PAGE 2
TAKE DOWN INSTRUCTIONS: NOTE: For long-term storage: Remove the CANOPY & store separately. For short-term storage (1-2 weeks): It is acceptable to leave the CANOPY attached to STEEL SHELTER FRAME. Follow the previous steps and illustrations on other side of this tag in the reverse order: • Disconnect canopy CLIPS from 4 LEG POLES. • Push the LOCKING BUTTONS and telescope down the 4 LEG POLES. • Push the 4 GRAY BUTTONS to release the ROOF SUPPORT BRACKET. • Fold CANOPY and put back into the bag.