User's Manual

C orec es s 3213 Insta lla tion G uide
10
Troubleshooting
If you cannot connect to VDSL network, please check the status of the LEDs on the front panel,
and then ensure the following:
1.
Check the LAN LED
If the LAN LED goes off, ensure that the Ethernet cable is firmly connected both to the Ethernet
port on the Corecess 3213 and LAN port on your PC.
2.
Check the LINK LED
If the LINK LED blinks continuously and never stays solid on, ensure that the VDSL cable is
firmly connected to the LINE port on the Corecess 3213. If the LINK LED still blinks, contact
your VDSL service provider.
If the LINK LED goes off, turn off the power of the Corecess 3213 by pressing the power switch
and turn on the power again. If LINK LED still goes off, contact your vendor.
3.
Check your PC’s IP address
If all LEDs operate normally and cables are firmly connected to the ports, ensure that your PC’s
IP address is properly assigned. Otherwise assign a new IP address according to your
operating system.
Windows 95/98/ME
n
Click the Start
button and select
Run.
o Input Winipcfg and press the [Enter]
key.
p Select Ethernet adapter connected with
the Corecess 3213 and click
Release All.
q
Click Renew All.