User Manual

Wi-Fi Protected Setup (WPS) lets you join a secure WiFi

network without typing the network name and password.

Note: WPS does not support WEP network security.

1. Press the WPS button on the front panel of the E300

around 6 seconds. Release the button, then the WPS

LED blinks.

2. Within two minutes, press the WPS button on your

router or access point.

3. When the E300 connects to your existing WIFI

network successful, the E300 WIFI network name

would be changed into “E300_EXT”, and

the WLAN LEDs are all lit green. If the E300 fails to

connect, the WLAN LED1 would keep blinking, try it

once again. If still failed, use the Method 1 on page 06.

4. It is around half a minute to reboot the E300. You can

connect back the new SSID of E300 by locating the

suitable place you need (how to locate the repeater

please refer to the troubleshoots on Page 16).

Method 2: Connect with WPS