User's Manual

CONNECTING

Your Monitor to Your Computer

1. Turn OFF and UNPLUG your Computer until instructed otherwise.

2. Carefully unpack all the components and verify all the parts are present and

undamaged. (See page 8.)

3. Organize the cables you need and familiarize yourself with the connection

configuration. (For the CT1704, see pages 11 & 16.)

4. Lay the monitor on soft, clean bottom with the monitor screen to face the

ground.

5. Connect the 15-pin VGA Cable to the Monitor’s “VGA” connector.

6. Connect the 15-pin VGA Cable to your Computer.

7. Plug the Audio Cable into the Monitor’s “AUD IN” connector.

8. Connect the Audio Cable to your Computer at the speaker card location.

9. Connect the power flex with the 'PWR(POWER)' connector on monitor.

REMINDER :

Using your fingers, hand-tighten the screws on the 15

Pin connectors.

NOTE :

To use a headset, plug the headset into “AUD OUT

”

connector on the Monitor.

TIP:

For easier access to the cable connections, keep th

Monitor laying (screen-side down) on a smooth surface.