Service manual

Quest Elite QLT 2000

Semi-Annually - Clean the Water Inlet Strainer

1. Pull the AC plug from the wall outlet

2. Remove the right side panel from the dispenser.

3. Turn off the water supply to the dispenser.

4. Remove the access port from the “Y” shaped water inlet solenoid

cated on the right side of the dispenser.

5. Clean and reinstall the stainless steel water strainer.

Annually - Cleaning the cabinet

The cabinet bottom surface and walls should be inspected and cleaned annually following the instructions below.

1. Remove natural rubber nozzle bushing gasket

and inspec

t it and Silicone RTV.If cracked,

cleam off RTV and re-apply using kit P/N

729011013 per instructions provided with the

Kit.

2. Re-apply nozzle bushing gaskets so that the

ges lie flat ont the floor of the cabinet.

3. Clean the cabinet floor and w

alls of any spilled

juice and let dry. Use a mild soap/detergent

and plain water.

4. Re-install the pump platform in the reverse

der given above.

For more information, refer to the Planned Maintenance Cards found in the Appendix of this Manual.

Daily maintenance tasks

BE 20 D1Flush orange juice system.

Weekly maintenance tasks

BE 20 W1Sanitize orange juice system.

BE 20 W2Check orange juice Ratio.

Monthly maintenance tasks

BE 20 M1Clean condenser filter.

Figure 55.

Figure 56.