Service manual

569000203E

Vanguard 245 Service Manual

- 12 -

IDENTIFICATION OF LOOSE-SHIPPED PARTS

1. Drip tray holder brackets to be installed on the unit and secured with screws, then

drip tray holder to be installed on the drip tray holder brackets and secured with

screws. Drip tray is to be installed in the drip tray holder, then the cup rest is to be

installed in the drip tray.

2. Rear access cover is used to cover the rear access hole on back of the unit and

secured with screws, thread cutting if drip tray and water tank drain hoses, water

tank overow hose, and the syrup and water source inlet lines to be connected to

the unit will not be routed through the access hole.

3. Splash guards are to be installed on the Unit and secured with front access panel

retaining screws.

4. Drip tray drain hose is to be connected to the drip tray and secured with Clamp, drip

tray drain hose.

5. Cup lid holder (optional) to be installed on the unit as shown.

6. Straw holder (optional) to be installed on the unit as shown.

SELECTING LOCATION

DANGER: To avoid possible fatal electrical shock or serious injury to the

operator, it is required that a GFI (ground fault circuit interrupt) be installed

in the electrical circuit for the domestic Units. It is required that an ELCB

(earth leakage circuit breaker) be installed in the electrical circuit for the

export Units.

Cup Holder

(Optional)

Splash Guard

Cup Rest

Drip Tray

Drip Tray Holder

Straw Holder

(Optional)

Splash Guard

LOOSE PART INSTALLATION