® MILLENNIUM II 6000 Installation Manual Release Date: April 29, 2003 Publication Number: 620919546INS Revision Date: July 1, 2003 Revision: A Visit the IMI Cornelius web site at www.cornelius.com for all your Literature needs.
Publication Number: 620919546INS © 2003, IMI Cornelius Inc.
TABLE OF CONTENTS Unit Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Receiving & Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Publication Number: 620919546INS © 2003, IMI Cornelius Inc.
Millennium II 6000 Installation Manual UNIT SPECIFICATIONS 26.125 [ 663,57 17.600 [ 447,04 ] ] 12.523 [ 318,1 32.048 [ 814,03 ] ] 10.389 [ 263,88 ] 9.090 [ 230,89 ] Model Number: Millennium II 6000 Electrical Ratings: 115 VAC / 1 Phase / 60HZ / 11.1 Amps 230 VAC / 1 Phase / 60HZ / 5.50 Amps 230 VAC / 1 Phase / 50HZ / 6.
Millennium II 6000 Installation Manual INSTALLATION RECEIVING & UNPACKING 1. Inspect the carton and note any damage, regardless if it appears minor. If the carton is damaged, note on the consignee copy of the freight invoice “exterior carton damage – concealed damage possible”. 2. Cut the banding strap and remove the exterior carton sleeve, internal fillers and plastic bag around the dispenser. Carefully inspect for damage. NOTE: IMI Cornelius is not responsible for damaged freight.
Millennium II 6000 Installation Manual NOTE: The dynamic water pressure must be 20 psig (1.3 Bar) minimum to ensure correct valve flow control and must not exceed 100 psig to avoid valve damage. 6. Filling the Ice Water Bath A. Remove the top panel and locate the filler hole in the top of the refrigeration deck. B. Fill the water bath with cool water until it begins to trickle out of the overflow tube and into the drip tray. Use tap water.
Millennium II 6000 Installation Manual • Green ON = line voltage is within acceptable range 11. Connecting the Drain A. Remove the drip tray from the dispenser and drill out the stem with a 7/16” (11 mm) drill bit. B. Route one end of the 5/8” (15.8 mm) ID hose through the hole in the back of the dispenser marked “drain” and up to the drip tray fitting located on the dispenser under the drip tray. C. Attach the hose to the drip tray fitting on the dispenser. D.
Millennium II 6000 Installation Manual B. Sample the finished drink. Increase or decrease the water ratio by inserting a flat blade screwdriver into the slot behind the flavor label and turning the water flow control screw clockwise (more water) or counter–clockwise (less water) until the desired water to concentrate ratio is achieved. Repeat the procedure on the remaining valves. C. Replace the flavor strips.
Millennium II 6000 Installation Manual CLEANING & SANITIZING CLEANING & SANITIZING THE SYSTEM The dispenser must be cleaned and sanitized after installation and as required by state and local health departments, or every three months minimum. The state and local health codes may require more frequent and extensive sanitizing procedures. 1. Cleaning and Sanitizing Equipment and Supplies A.
Millennium II 6000 Installation Manual E. While waiting, remove the nozzles and static mixers and place them into a separate container with 2 quarts (1.9 l) of sanitizing solution. Agitate vigorously using the small brush to remove any excess concentrate. Allow the parts to soak for 30 minutes. F. Clean the dispensing valves mixing chamber (this is the cavity from which the nozzle is removed) with the brush and sanitizing solution. G.
Millennium II 6000 Installation Manual NOTE: It will be necessary to melt the ice bank to be able to pull the refrigeration deck up and away from the dispenser. Warm water may be used to accelerate the melting. In order to prevent ice bank control damage, do not direct the warm water stream on to the sensing probe of the ice bank control. Never use an ice pick or other instrument to remove ice from the evaporator. Such practice can result in a punctured refrigerant circuit or damage to the water bath tank.
Millennium II 6000 Installation Manual PANEL REMOVAL 1. Loosen the retaining screw on top of the merchandising panel. 2. Depress the center of the merchandising panel. 3. Slide the top panel about 1 inch toward the rear of the unit and lift it off. © 2003, IMI Cornelius Inc.
Millennium II 6000 Installation Manual 4. Disconnect the wires from the key and power switches (black wires - key switch; brown wires - power switch). 5. Remove the cup rest and drip tray assembly. 6. Remove the splash panel by lifting up and pulling the bottom out. 7. Slide the side panels forward approximately 2 1/2 inches and lift off. Note: There are 3 locking tabs on the water tank and 3 on the unit base. Publication Number: 620919546INS - 10 - © 2003, IMI Cornelius Inc.
Millennium II 6000 Installation Manual 8. Lift the rear panel up and off. 9. Disconnect the agitator motor wires to remove the merchandiser. 10. Refrigeration deck removal: A. Remove the inlet water line from the John Guest fitting on the dual water coil. B. Remove the John Guest fitting from the dual water coil. © 2003, IMI Cornelius Inc.
Millennium II 6000 Installation Manual C. Disconnect all of the connectors from the back of the control box. D. Remove the retaining clips from both sides of the water tank before lifting refrigeration chassis. E. Lift the refrigeration out of the water bath. Publication Number: 620919546INS - 12 - © 2003, IMI Cornelius Inc.
IMI Cornelius Inc. One Cornelius Place Anoka, MN 55303-1592 U.S.A.