Installation manual

Viper Installation Manual

BACKROOM REQUIREMENTS

Typically the supplies for the unit are located in a backroom adjoining the service

area. Syrup, water and CO

2 lines are then run from the backroom to the service

area. The backroom supplies (syrup boxes, CO

2, water filters and pumps) are

typically installed on a rack system that sits on the floor, as shown in Figure 2.

The CO

2 cylinder is normally mounted against the wall.

Figure 2

SUPPLY CONNECTIONS

All of the electrical and supply connections to the unit are typically located near

the bottom rear of the unit. There are alternate locations for the electrical and

supply connections on the bottom of the unit, below the rear locations. The

bottom connection locations may be used if the unit is located directly against a

wall.

The electrical connection is located at the left side of the rear panel and the

tubing supplies are located on the right side, as shown in Figure 3.