Installation manual

Viper Installation Manual

Electrical Connections

To connect AC power to the unit, perform the procedure in Table 2. 60Hz units

are supplied with the power cord attached. Skip installation information in Table

2 and begin with the Water Supply Requirements section.

Figure 4

Table 2

Step Action

1 Insure that power to the unit is off. DO NOT plug the power cord into the

wall outlet at this time.

2 Remove the right side and rear panel from the unit.

3 Remove the cover from the electrical box.

4 Feed the power cord through the strain relief, as shown in Figure 4.

5 Pull the slack out of cable and tighten the strain relief (see Figure 4).

6 Connect the colored wire to the appropriate terminal on the terminal block.

7 Connect the black wire to the appropriate terminal on the terminal block.

8 Connect the green wire to the ground terminal next to the terminal block.

9 Replace the power box cover. DO NOT TURN ON THE POWER at this

time.

Strain Relief

Terminal

Block