Installation manual

Viper Installation Manual

Pressurizing the Water System

Perform the procedure in Table 13 to verify the water connection to the unit.

Figure 17

NOTE:Remove the valve cover to access syrup and water valves.

Table 13

Step Action

1 Turn on the water supply to the unit.

2 Check the system for leaks.

3 The Do Not Drink and Out of Product lights remain on. NOTE: The H2O

Out error does not clear until CO2 pressure is applied.

4 Turn the product supply valve to the down (BRIX) position and open the

valve at the end of the sample tube.

5 Place the end of the tube in a bucket.

6 Manually lift the water valve at the front of the unit (Figure 17) to fill the

water system.

7 When water flows from the sample tube, the system is full and you may

proceed to Table 11 and pressurize the CO2 system.

8 Repeat Steps 4 through 7 for each barrel in the unit.

Manual

Water

Valve

Manual

Syrup

Valve

(push up to open)