ICE FROST Post-Mix and Pre-Mix Installation, Service, and Operator's Manual

Ice Frost Operator’s Manual

Problem Possible Cause Solution

Cap is leaking • The nut is loose • Tighten the nut

Bowl not refilling • Out of syrup

• Out of CO

• Valves are shut off or blocked

• Foam covering probes

• Fill Switch in off position

• Defective syrup pressure switch

• Defective CO

shut off

• Replace

• Open

• Wait

• Turn on

• Replace

Bowl is overfilling • Bad Pressure and Levels Card • Replace the card

leaking from back of unit • Proper function of bowl over

pressure discharge solenoids

• Poor connection

• If not continuous leak it is nor-

mal operation

• Repair leak

WARNING: Relief valve venting is normal, a continuous leak is not and must be corrected immedi-

ately. Repair the solenoid valve.