User Guide

IDC Icemaker Adaptor Kit Installation Instructions
© 2005-2006, IMI Cornelius Inc. - 1 - Publication Number: 629088667INS
INSTALLATION INSTRUCTIONS
IDC ICEMAKER ADAPTOR KIT FOR P/N 629088667
1. Place ice slide into ice drop opening in
bin (see FIGURE 2).
2. Place bar into first set of pockets inside
the ice bin.
3. Hook cross braces over top of bar and
place into inner pockets inside the ice
bin (at back end).
4. Place Icemaker Adaptor Kit on top of
unit.
5. Place icemaker on top of kit. DO NOT
slide icemaker into position on the lid.
6. Apply continuous bead of NSF
international (NSF) listed silastic
sealant (Dow 732 or equivalent),
supplied in kit, to seal the icemaker to
the top of the adapter kit. All excess
sealant must be wiped away
immediately.
7. Drill 9/64” diameter holes, using one of
the two supplied brackets as a
template, into the rear of the icemaker
and the rear of the icemaker adapter
kit. USE EXTREME CARE NOT TO
DRILL INTO ANY ICEMAKER
COMPONENTS!!! Secure the icemaker
to the adapter using the screws and
brackets provided.
8. For optimal performance, do not fill ice
bin more than 2/3 capacity (maximum
fill is 4” below top of bin). Applies to IDC
255 models only.
FIGURE 1
FIGURE 2. Ice Slide Assembly
Icemaker
Adaptor
Kit
Bar
Cross
Braces
Ice Slide
Release Date: January 27, 2006 www.cornelius.com Revision: B