Service manual

Quantum Series Installation and Service Manual

CONCENTRATE LOADING AND BRIXING

PLACING CONCENTRATE PRODUCTS ON DISPENSING PLATFORM

To engage the concentrate container, place it in the desired position and press down into bottle adapter opening

on dispensing platform tray (inside the cabinet).

NOTE: Make sure o-ring seal on the container adapter is lubricated; otherwise, you may experience

difficulties with container replacement.

NOTE: Concentrate in the containers must be completely thawed and be within the temperature range

of 35°F

- 40°F (1.6°C - 4.4°C). Failing to supply concentrate inside the recommended tempera-

ture range, especially below 35°F (1.6°C), will cause an out of brix drink.

It is recommended the concentrate be thawed in a refrigerated (35°F - 40°F) (1.6°C - 4.4°C) compartment for 36

to 48 hours before use.

It is recommended that the thawed concentrate be thoroughly shaken before use.

CHANGING CONCENTRATE FLAVOR

1. Perform flush cycle

2. Move valve handle to “Dispense” position

3. Replace concentrate container

PUMP PRIMING

1. Follow instructions in paragraph “Placing Concentrate Products on the Dispensing Platform”

2. Close the door (or unit will not activate)

3. Depress the push button until concentrate appears at the dispensing nozzle.

BRIX SETTING

1. Make two (2) full clockwise turns of the corresponding brix knob from the “all the way out” position (factory

set). These two turns will bring you within one turn of proper brix setting. (Refer to brix table located on the

inside of the refrigerated compartment door).

2. Dispense 1/2 cup of juice and discard.

3. Dispense 1/2 cup of juice and use refractometer to check brix level.

4. Clockwise rotation of the knob decreases brix level for example from 13% to 11.5%. Counterclockwise will

increase brix level for example from 11.5% to 13%.

If a brix problem is experienced, refer to troubleshooting guide.