Service manual

Quest Elite 4000 Service Manual

Figure 14. Interior Details

5. Slide the locking latch forward. Lift the platform slightly and pull forward to

gain access to the electrical connector (see Figure 14).

6. Unplug the electrical connector by squeezing the locking tabs on either side and

pulling out the connector. Lift and remove the pump platform (see Figure 14).

Replacing the Tubing When the pump platform has been removed, replace the tubing by performing the

following procedure.

1. Remove the two white plastic hose clamps from the pump tube connections

(See Figure 14) and remove the concentrate delivery tubes from the hose ends.

2. Loosen and remove the four screws from the pump body (See Figure 15).

Front & Rear

Pump Halves

Pump Motor

Water Manifold

Water Solenoid

Locking Latch

Bottle Adapter

Juice Inlet

Water Inlet

Quick Connector

Pump Body Screws

BRIX Adjustment Screw

Concentrate

Delivery Tubes