User manual

Thermostat Reset Upgrade Kit Installation Instructions

4. Remove thermostat wires from their

connections. Feed the wires out of the

contactor box. Discard the black jumper

wire.

5. Feed the white wires that originate from

the safety circuit box out of the contactor

box.

6. Pull out safety circuit box and remove the ground screw. Disconnect the main power and contactor

harness leads for the contactor.

7. Feed the white wires out through the hole and remove the box.

NOTE: Note the mounting hole locations on

the original box. If the mounting holes are on

the side of the box, proceed to step 14.

If the mounting locations are on the top and

bottom, remove all wires and bushing and

proceed to the next step to drill new

mounting holes.

Disconnect white

contactor wire from

thermostat wire.

Disconnect black

jumper from thermostat

wire and discard.

Remove the two white wires

and black thermostat wires

from contactor box.

Box with mounting holes on

top and bottom. Drill new.

Box with mounting holes on

sides. Use existing.