User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications DRAFT User Manual I CMA-XXX-AEN I Page 13
1.4 User Controlled Service Group Distribution
Corning
optical network evolution (ONE
™
) solutions fiber-optics infrastructure allows various combinations of wireless services
to be routed from the headend to specified remote locations on each floor, according to user defined configurations. This allows
optimizing service coverage and provides equipment savings. While the fiber-optics infrastructure is common, the services can
be routed via service provider shared or dedicated equipment. By default, the system is configured to support a single service
group: all services are transferred to all remote locations. This default configuration can be easily modified according to site
requirements.
Figure 1-2 illustrates service distribution from the head-end to various locations on each remote floor. Each color represents a
specific service, where different combinations of services are distributed at various locations on the same floor according to
coverage requirements.
Figure 1-2. Illustration of Service Group Distribution