User's Manual

Corning Optical Communications DRAFT User Manual I CMA-XXX-AEN I Page 17
1.5 Web Management Application
The headend control module (HCM) enables centralized, system-level element management and provides c omprehensive
end-to-end, single source setup and management of the active RF components after their physical installation
.
Note: Refer to the Corning optical network evolution (ONE
™
) solutions HCM and Management GUI user manual for a complete
description of the Web management application.
Figure 1-7 shows the Management window, displayed by default upon login.
Figure 1-7. Example of Management Window (Software v2.2)
The main menu bar includes the following tabs:
Tab
Description
Management
Displayed upon login by default. Displays general module information and
device alarms and provides the configuration options for the available
selected site devices.
Events Displays the events that occurred on the monitored devices and enables
generating reports. Configuration changes that are initiated by the network
manager are not considered events display.
Config
Set-up tool used for initial system set-up, commissioning of system devices
and adjustment procedure.
Admin Provides administration options such as firmware upgrade, user management
options and IP settings required for receiving traps.
Profiles
Enables creating complete system configuration and setup profile offline and
activating at a later time (software v1.8 and higher).
Location
Enables importing maps and icons to graphically display the geographical
location and types of sites as well as the floor plans and map power settings
for the system elements (software v1.8 and higher).
Multilink
Displays list of all of the setups configured in the same network and enables
access to authorized users (software v2.0 and higher).
Help
Provides access to online help
Table 1-2. Main Menu Tabs