User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications DRAFT User Manual I CMA-XXX-AEN I Page 23
2.1.4 Optical Interface Module (OIM)
The OIM is a wideband RF to F/O (and vice-versa) media conversion
module. Up to 12 OIM units can be installed in each OIU, where each OIM
can support connections up to three remote units connections.
Port
Description
OPTICAL LINK
Female MTP
®
Connector for optical interface
connection; SM fiber
1:1
INTERFACE
Six pin SMP jack connector for 1:1 direct signal
transportation, three UL and three for DL enables (DL
and UL) broad band connection to each optical link
Table 2-9. OIM Ports Description
LED
Description
Link 1-3
Steady Green - optical link power to/from the
connected remote is normal
Off - no optical power from remote detected
RUN
Blinking Green – OIM module software has initialized
and is up and running
Off – Power off
PWR Steady Green – Input power detected in OIM
Table 2-10. OIM LED Descriptions
Figure 2-6. Optical Interface Module
2.1.5 Optical Expander Module (OIX)
The OIX provides the RF interface to two RIX modules via two
9-pin connectors.
.
Figure 2-7. OIX Interfaces