User's Manual

Corning Optical Communications DRAFT User Manual I CMA-XXX-AEN I Page 36
4.2 IHU Installation
4.2.1 Unpacking and Inspection
Unpack and inspect the cartons as follows:
1. Open the shipping cartons and carefully unpack each unit from the protective packing material.
2. Verify that all the items required for installing the chassis according to the items listed in the corresponding sections. If any of
the listed items are missing, contact your Corning representative.
3. Check for signs of external damage. If there is any damage, call your Corning representative.
IHU Kit
Quantity
Item
Integrated headend unit chassis
1
Fan Module (S-FAM) – single unit hosting 4 fans
(installed in the chassis rear)
1
RJ45/RJ45 communication cable L=2m-2.15m (P/N 705900003) –
HCM management cable
1
Cable Management Tray - includes management tray with routed
ERFC cable and door sleeve
ERFC (Expander Cable) - RF interface cable between RIX and OIX
modules; 9 pin SMP to SMP connector; L=34 in
1
RIM Kit (up to 8 according to order)
Quantity
Item
radio interface module (service specific) 1
OIM Kit (up to 8 according to order)
Quantity
Item
Optical Interface Module (OIM) 1
MTP-LC APC Harness Cable (P/N 37HP900162-006F) - connector
for splitting fibers (6) leading from OIM to (FMU) Edge module
1
RIX Module Kit
Quantity
Item
Radio Expander Module – expands the RF sources to the OIM
modules via the OIX
1
Pilot Transport Cable (P/N: PCKC47*) – Single QMA to QMA cable;
L = 47 in; used for passing reference clock signal connections
between RIX modules.
*Additional various lengths are available:
• PCKC20: L=20 in
• PCKC63: L=63 in
1