User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications DRAFT User Manual I CMA-XXX-AEN I Page 37
• PCKC79: L=79 in
OIX Kit
Quantity
Item
OIU Expander Module - connects to the RIX Expander module;
provides RF interface between RIM and OIMs
1
PSM Kit (AC or DC modules - 1 or 2 kits according to order)
Quantity
Item
PSM-AC: 100-240 VAC Power Supply Module including standard
IEC 60320-1 C13 cable
1
PSM-DC: 48 V DC Power Supply Module; 9 A Max.; Includes six pin
terminal block connector
1
Controller Module Kit (HCM or ACM - according to order)
Quantity
Item
HCM Kit (headend control module) – installed in IHU unit; enables
remote/local management of all hosted units
1
ACM Kit (auxiliary control module) – for system setups with two
IHUs; installed in second IHU unit; provides management
connections for the second IHU.
1
Table 4-1. Items Required for IHU Installation