User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications DRAFT User Manual I CMA-XXX-AEN I Page 42
2. Referring to Figure 4-11 secure the units’ rack ears to the
rack frame as follows:
− Insert two screws half-way into the rack frame.
− Position the chassis on to the screws using the handles
and the bottom half slots of the rack ears.
− Secure the unit in the rack via all applicable bracket
holes using the appropriate rack nuts and screws.
Figure 4-11. Installing Chassis in Rack (shows HEU as
example)