User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications DRAFT User Manual I CMA-XXX-AEN I Page 48
4.6 Management Connections
Note: RJ-45/RJ-45 management cable is provided with each IHU.
To connect the management connections
1. Connect the HCM module LAN port to the corporate LAN using
the provided RJ45/RJ45 communication cable. See Figure 4-22.
2. For system setups with two IHUs:
From HCM INTERNAL port to the ACM INTERNAL port (any of
the four ports can be interconnected). Refer to Figure 4-22.
Figure 4-22. HCM LOCAL Port to ACM Port LOCAL
Management Connection
4.7 Power Connections and Power Up
Note the following:
• PSM-DC can be installed and activated simultaneously in the same chassis along with a PSM-AC module.
• For installations with two PSMs, both modules must be:
− Connected to their respective power source (AC or DC)
− Switched on to begin system operation
− Turned on at all times after installation
4.7.1 AC Power Connection (PSM-AC)
To connect the AC Power to the PSM-AC
1. Connect power cable (100-240 VAC) supplied with
module to the PSM-AC input connector and to the AC
outlet and switch on. See Figure 4-23
2. Verify that the Power Status LED on each PSM is GREEN.
Figure 4-23. PSM-AC LEDs