User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications DRAFT User Manual I CMA-XXX-AEN I Page 51
OIM LED
Description
LINK 1/2/3 Steady green - optical link power to/from the
connected remote is normal
Blinking green - optical power from remote is lower
than required
RUN Blinking green - module software has initialized and
is up and running
Off – power off
PWR Steady green - power input detected in OIM
Table 4-6. OIM LED Descriptions
Figure 4-31. OIM LEDs