User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications User Manual I CMA-490-AEN I Page 52
5 PSU6 INSTALLATION
This chapter describes the installation procedures for the PSU6.
5.1 PSU6 Installation
The PSU6 enclosure includes the DC connectors and power LEDs, and supports up to six power supply modules (PSMs). The
PSU6 supports Corning optical network evolution (ONE™) solutions remotes and can also power the following specified
network interface devices (NIDs):
• Tellabs™ - P/N Tellabs
®
709GP ONT
• Zhone® - P/N ZNID-GPON-2624P-00
• Antaira® - P/N LMP-0601G-SFP-T
5.1.1 Items Required for PSU6 Installation
The following kits and included items are required for installing the PSU6. If any of the listed items are missing, contact your
Corning representative.
PSU6 Kit
Quantity
Item
PSU6 1
AC power cable US plug, 90 degree, length 1.8
m-2.5 m
1
Wall mount bracket 2
DC terminal block; two pole with screw for wire
(Manufacturing PN: Dinkle MP/N
2ESDV-02P)
Note: The DC terminal blocks are pre-inserted
into the units’ DC connectors.
12
Power Supply Module Kit (1 to 6 according to
order)
Quantity
Item
Power supply module 1
Table 5-1. Required Kits for PSU6 Installation