User's Manual

Corning Optical Communications User Manual I CMA-490-AEN I Page 58
6 MRU INSTALLATION
6.1 MRU Indoor Installation
6.1.1 Unpacking and Inspection
Unpack and inspect the cartons as follows:
1. Open the shipping cartons and carefully unpack each unit from the protective packing material.
2. Verify that all the items listed in Table 6-1 are included in the MRU package. If any of the listed items are missing, contact
your Corning representative.
3. Check for signs of external damage. If there is any damage, call your Corning representative.
Kit
Item Description
Quantity
MRU Mid-power remote unit
Note: See ‘Appendix B: Ordering Information for MRU part
numbers.
1
Hosted Modules
(pre-installed)*:
Service specific power amplifier
modules (PAMs) – pre-installed
according to ordered configuration
1 - 5
Fan module (FAM) 1
AC or DC (model dependent) power
supply module (PSM)
1
AC power cable (AC
models only)
Cable, power, straight, USA 10A ,UL,
L=1.8-2.5m ,black,110V
1
Rack ears for 19-in rack (factory assembled onto sides of
MRU)
2
Table 6-1. MRU Kit
* ATTENTION! In the event that a PAM or the OPTM needs to be removed from the chassis, make sure to first press the release button on the module and
then pull out using the handle. Any attempt to pull out the module without first releasing may cause damage. Refer to Section
Error! Reference source not
found.for more details.
Corning will not be liable for damage of products resulting from improper handling during installation or repair.