User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications User Manual I CMA-490-AEN I Page 65
6.1.4 Fiber Connections
To connect optic fiber
Remove the LC APC connector plugs.
1. Using Corning
®
SMF-28
®
fiber (or compatible), connect the MRU LC APC fiber connector fiber patch panel. See Figure 6-6.
Figure 6-6 Fiber Connections toward Fiber Patch Panel
6.1.5 RF Antenna Connections
Connect the MRU male DIN type 4.3-10 duplexed RF “ANTENNA” port to the broadband antenna(s) using appropriate coax
cables. See Figure 6-7.
The MRU includes one 4.3-10 Type RF port used for connecting to a 2.5 GHz external RF source (e.g. picocell).
Figure 6-7 Example of MRU Connections to Broadband Antennas (Via Splitter)