User's Manual
Table Of Contents
- 1 Introduction
- 2 Unit Descriptions
- 3 Installation Guidelines
- 3.1 General System Specifications and Requirements
- 3.2 Infrastructure Preparation
- 3.3 Antenna Specifications and Guidelines
- 4 IHU Installation
- 4.1 General Installation Information
- 4.2 IHU Installation
- 4.3 Grounding Chassis
- 4.4 RF Connections
- 4.5 IHU Fiber Connections
- 4.6 Management Connections
- 4.7 Power Connections and Power Up
- 4.8 Verifying Normal Operation
- 5 PSU6 Installation
- 6 MRU Installation
- 7 Appendix A: Specifications
- 8 Appendix B: Ordering Information
Corning Optical Communications User Manual I CMA-490-AEN I Page 66
6.1.6 Power Connections
The MRU power connections depend on the type of power module (AC or DC). The power supply module (PSM) is located on
the bottom right of the chassis front.
• Refer to Section 6.1.6.1 for AC model power connections
• Refer to Section 4.6.2 for DC model power connections
6.1.6.1 AC Models
Using the provided AC power cable only, simply connect the MRU AC power connector to the AC power source.
Note the following:
• Power input: 100-240 VAC / 50-60 Hz
• Power consumption: 360 W (max.)
• Maximum AC current consumption: 5A
Figure 6-8. MRU AC Model Power Connector