User's Manual
Table Of Contents
- Corning
- ONE™ Wireless Platform
- User Manual
- Preface Material
- About This Manual
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- Regulatory Compliance Information
- RF Safety
- CAUTION!
- Laser Safety
- Licensee Contact Information
- Additional Relevant Documents
- Table of Contents
- 1 Introduction
- Figure 1-1. Illustration of Precise Service Distribution over Selected Remote Areas
- Table 1-17. Ethernet Path Units
- Figure 1-2. Corning ONE Wireless Platform Basic Architecture
- Figure 1-3. Corning® ONE™ Solution RF Path Architecture
- Figure 1-4. Corning ONE™ Solution Ethernet Path Architecture
- Figure 1-6. Illustration of Service Group Distribution
- Figure 1-7. Single Service Group Configuration
- Figure 1-8. Example of Dual Service Group Configuration
- Figure 1-9. Example of Three Service Group Configuration
- Figure 1-10. Example of Tri-Service Group Configuration with Two HEUs
- Figure 1-11. Example 1 of FMM-to-FRM Service Distribution
- Figure 1-12. Example 2 of FMM-to-FRM Service Distribution
- 2 Unit Descriptions - RF Path
- Figure 2-1. RF Path with HEU and OIU Headend Components
- Figure 2-2. RF Path with IHU Headend Component
- Figure 2-3. Example of HEU with Installed Modules
- Figure 2-4. HCM Module
- Figure 2-5. ACM Module
- Figure 2-6. RIM Module
- Figure 2-7.FRM
- Figure 2-8. RIX Expander Module Interfaces
- Figure 2-9. Expander Termination Module
- Figure 2-10. PSM-AC Power Supply Module
- PSM-DC
- Figure 2-11. DC Power Supply Module
- Figure 2-12. OIU Front Panel with Installed Modules
- Figure 2-13. Optical Interface Module
- Figure 2-14.FMM
- Figure 2-15. OIX Expander Module Interfaces
- Figure 2-16. IHU Front Panel with Installed Modules
- Figure 2-17. RF Path Remote-end Components
- Figure 2-18. ICU Front Panel Interfaces and Modules
- Figure 2-19. ICU Rear Panel Interfaces and PSM Modules
- Figure 2-20. RAU Module Interfaces
- Figure 2-21. RAU LEDs
- Table 2-19. RAU Status LEDs Description
- Figure 2-22. RAU5 Interfaces
- 3 Unit Descriptions - Ethernet Path
- Figure 3-2. CEU Front Panel with Installed CEM Module
- Figure 3-3. CEU Rear Panel
- Figure 3-5. CEM LEDs
- Figure 3-6. GEM Interfaces
- Figure 3-7. GEM LED Description
- Figure 3-8. GEU Enclosure: Top (Left) and Open Underside (Right)
- 4 Installation Guidelines
- Figure 4-1. Example of Communication Rack Installation
- Types of Power Supplies
- 5 Appendix E: Specifications
- RF Parameters for FCM Solution
- Optical Specifications
- Standards and Approvals
- RF Path: Coverage Component Specifications
- Fiber Connectivity Module (FCM) Specifications
- 6 Appendix F: Ordering Information
- HEU and OIU Assemblies and Modules
- Remote Units
- SFP+ Modules
- Ethernet Path Units
- Hardware
- Cable Ordering Information
- Cable Configurations
Appendix F: Ordering Information
CMA-331-AEN
Page 90
Ethernet Path Units
Part Number
Description
GEU-S Standalone Gigabit Ethernet unit
CEU Centralized Ethernet unit; hosts up to three CEM modules
CEM Centralized Ethernet module; includes SFP and UPC to APC adapter
Accessories
Part Number
Description
CblTray
HEU/OIU Cable management tray and door sleeve; chassis sleeve for managing
cables and door for covering front panel
AK-RAU-BRCK-MM
Accessory kit used for mid-mount acoustic ceiling installations of the RAU; includes
flat bar and plate for assembling the RAU; assembly replaces standard acoustic tile
(RAU ordered separately)
RAU5US-ANT Broad Band Antenna Module for RAU5-Remote Access Unit
BR-RAU5US-Wall
RAU5 remote bracket for wall mount installation; Supports up to two RAU5 units
back-to-back
BR-RAU5US-TOP RAU5 bracket for floating ceilings tile, Mid-Mount installation
37HP900162-006F
MTP-LC APC Harness Cable; Connector for splitting fibers (six) leading from OIM to
(FMU) Edge module
FCM Accessories:
AK-BR-DCF 19 in/1U rack-mount enclosure; Supports two AK-DCFxxxx cassettes
AK-DCF0408
Dispersion compensating fiber; DSCM for compensation of 6.2 miles (10 km) SM
fiber, LC/APC connectors, standard box
AK-DCF0811
Dispersion compensating fiber; DSCM for compensation of 9.3 miles (15 km) SM
fiber, LC/APC connectors, standard box
AK-DCF1112
Dispersion compensating fiber; DSCM for compensation of 12.4 miles (20 km) SM
fiber, LC/APC connectors, standard box
ERFC:
Expander RF Cable; SMP to SMP connector
ERFC16 L= 16 in; 9 pin
ERFC24 L= 24 in; 9 pin
ERFC34 L= 34 in; 9 pin
ERFC40 L= 40 in; 9 pin
ERFC59 L= 59 in; 9 pin
PCKC:
Pilot Transport Cable; Single QMA to QMA
PCKC20 L=20 in
PCKC47 L=47 in
PCKC63 L=63 in
PCKC79 L=79 in