User's Manual
Table Of Contents
- Preface Material
- Policy for Warrantee and Repair
- Safety Instructions
- Warnings and Admonishments
- Standards and Certification
- About this Guide and Other Relevant Documentation
- Table of Contents
- 1 Introduction to GX System
- 2 System Installation
- 3 Commissioning MA Head-End
- 4 Provisioning the MobileAccessGX
- Appendix A: System Specifications
- Appendix B: Ordering Information
- Appendix C: Site Preparation
MobileAccessGX Installation and Configuration Guide 6
1.4 GX Unit Interfaces
All of the GX interfaces are located externally on the underside of the unit (facing down when
unit is mounted). The unit interfaces include the RF, power and optical link connectors.
Figure 1-6: GX Interfaces – Underside Panel
The following tables provide a description of the GX connectors and LEDs.
Connector
Description
Service Connectors
(e.g. 850MHz, 700MHz, AWS)
DIN female connectors to antennas
OP
SC/APC optical fiber access port (waterproof) connection
to OCH for either SM or MM fibers.
AC
Remote Power (AC) Power feed options: 100-240 V AC
50Hz/60Hz
Max Power Consumption: 1400W
LAN
RJ45 connector for local connection (i.e. debugging,
troubleshooting)
EXT_ALM
N/A
FILTER_ IN/ FILTER_ OUT
Connections to external filter
Table 1-1. Connector Descriptions
Connectors located
on underside panel
Filter In port
AC power
port
OP port
Filter Out port
RF Service connector
RF Service connector
RF Service connector
RJ45 LAN
connector
RUN LED
Grounding
ALMLED
FSK LED